Many of my projects using a Bamboo Lab P1S 3D printer.
Using a .4 mm nozzle and PLA filament. Will play with a .2 mm nozzle for miniature people, etc.
and other filaments later.
Bought this in Oct 2024. I had a number of projects I wanted to do, but the traditional ways were insurmountable. So I splurged.....
The majority of these I have designed using Tinkercad. I will get links for the stuff I downloaded/paid for.
Some of these projects took tens of DESIGN hours to get right. Working at scales of .05 millimeter and smaller.
Others took near a hundred hours. Some are not yet done-done. Printing takes anywhere from 10 minutes to 9+ hours, each attempt.
  |
My dream home...is a quonset. |   |
A holder to display 3 glow wands used in "A Christmas Carol" at Zach Scott Theater. The ring is new for 2025. |   |
Display adapter, Pi holder, and Battery holder for my Lynx to pocket media center. | |||
 |
Ver. 1 of a hard-to-find round case to hold a collectable. Complete with an LED option. Only the spiral tree inside is 3D printed. |  |
A robot lamp needs new joints. May wait until I get a tougher filament to use. |   |
A Halloween decoration. LINK: |
|||
 |
A grid alignment for some neat switches I got from the now defunct All Electronics. |  |
An LED alignment tool for a stereo vuemeter kit from Silicon Chip magazine. LINK: |
 |
HP staricase. I added a few twinkling LEDs. LINK: |
|||
  |
iDimpy bars anyone? The plush comes from ImpulseSV of Hermitcraft streaming. I thought he needed a snack. |  |
Revisiting the case for my electronic ornaments after 20 years. Still working on the relay and the LED head. |  |
Minecraft ores. LINK: |
 |
||
 |
Word Watch version 1...the bug. |  |
Word Watch version 2...the bracelet. |  |
Word Watch version 3...the slim. This the winner. | |||
  |
Star Trek interface, the tiny power button at the bottom. And yes, the 4 switch wall plate is a 3D print. Dragon is found..LINK: |  |
Not everything is better 3D printed. A replacement drive shaft (for a Mr. Christmas Santa House) was too thin, so I used grommets and washers. |  |
Here is a replacement battery(I hacked out the versapak holder) for my Stickbroom blower with a display. Will it survive the current draw? Regular Holders for 18650 batteries to come. Single and double, a special one to replace Versapak batteries in tools I like. |
|||
| And a miriad of misc hooks, bins, knobs, shirt buttons, pens, eggs, and adapters. | Still pending are several Atari a8 projects. |  |
Here is as photo as 3D artwork. I plan to make my own. LINK: |
|||||
